Save 20% on select titles with code HIDDEN24 - Shop The Sale Now
This paper discusses the revision of SSPC-PA 9, “Measurement of Dry Coating Thickness Using Ultrasonic Gages.” This standard describes procedures to measure the thickness of dry, homogeneous coatings applied to concrete, wood, wallboard, plastic, fiber and composite material using commercially available ultrasonic coating thickness gages.
Conference Paper - This paper describes the requirements of the standard, additional inspection points, and several uses of the standard in the field where clear specification language was imperative to successful project completion. NACE 5/SSPC-SP 12 standard confined to water jetting - which makes use of ultra-high pressure water that is nonabrasive. Four levels of visible post-cleaning condition and three levels of non-visible condition are defined.
We are unable to complete this action. Please try again at a later time.
If this error continues to occur, please contact AMPP Customer Support for assistance.
Error Message:
Please login to use Standards Credits*
* AMPP Members receive Standards Credits in order to redeem eligible Standards and Reports in the Store
You are not a Member.
AMPP Members enjoy many benefits, including Standards Credits which can be used to redeem eligible Standards and Reports in the Store.
You can visit the Membership Page to learn about the benefits of membership.
You have previously purchased this item.
Go to Downloadable Products in your AMPP Store profile to find this item.
You do not have sufficient Standards Credits to claim this item.
Click on 'ADD TO CART' to purchase this item.
Your Standards Credit(s)
1
Remaining Credits
0
Please review your transaction.
Click on 'REDEEM' to use your Standards Credits to claim this item.
You have successfully redeemed:
Go to Downloadable Products in your AMPP Store Profile to find and download this item.
Quality Assurance/Quality Control (QA/QC), often referred to as inspection, is critical to the success of a protective coating or lining project. Several parties can and do get involved in inspection including the owner, specifier, third party inspector, general contractor, painting contractor, equipment supplier, and coating manufacturer.
In the spring of 2014, a new SSPC-PA21 standard is scheduled to be published. Despite the fact that this is the second major revision in as many years, new technologies and techniques have been introduced since the 2014 standard was revised and sent to ballot. Some examples include a factory-calibrated coating thickness gauge with pre-defined surface profiles, as well as a scanning probe designed to be slid across a cured coating while taking readings in real time. When these new technologies are put into practice, dramatic improvements in overall inspection times and data accuracy can be seen.