Menu
Search
Filters
Close
Menu

NACE SP0716-2016, Soluble Salt Testing Frequency and Locations on Previously Coated Surfaces

Picture for SP0716-2016
Available for download

HISTORICAL DOCUMENT. Test for the presence of surface soluble salts before application of a coating system.  Previously coated or eplacement  substrates  only. Does not include allowable limits of soluble salts.

Product Number: 21409-SG
Publication Date: 2016
Industry: Coatings and Linings
$179.00
$179.00
$179.00

HISTORICAL DOCUMENT. This NACE International standard designates where, how often, and the most likely places to test for the presence of surface soluble salts before application of a coating system. This standard establishes industry best practices for soluble salt testing frequencies and locations. It provides a consistent method of soluble salt testing for inclusion in written directions and specifications prepared by asset owners, engineers, consultants, coating contractors, inspectors, and others who are specifying allowable levels of surface soluble salts to prevent premature coating failures. This standard applies only to previously coated substrates and replacement substrate material, and does not include allowable limits of soluble salts. Key words: abrasive blast cleaned, chalking, coating failure, coating system, flanges, flash rust, girth weld, NACE Publication 6G186, nonvisible contaminants, nonvisible salts, oxide, oxidization, pipelines, salt contaminants, soluble salts, testing frequencies, TG 518, welds

HISTORICAL DOCUMENT. This NACE International standard designates where, how often, and the most likely places to test for the presence of surface soluble salts before application of a coating system. This standard establishes industry best practices for soluble salt testing frequencies and locations. It provides a consistent method of soluble salt testing for inclusion in written directions and specifications prepared by asset owners, engineers, consultants, coating contractors, inspectors, and others who are specifying allowable levels of surface soluble salts to prevent premature coating failures. This standard applies only to previously coated substrates and replacement substrate material, and does not include allowable limits of soluble salts. Key words: abrasive blast cleaned, chalking, coating failure, coating system, flanges, flash rust, girth weld, NACE Publication 6G186, nonvisible contaminants, nonvisible salts, oxide, oxidization, pipelines, salt contaminants, soluble salts, testing frequencies, TG 518, welds

Product tags
Also Purchased
Picture for SP0287-2016
Available for download

SP0287-2016, “Field Measurement of Surface Profile of Abrasive Blast-Cleaned Steel Surfaces Using a Replica Tape”

Product Number: 21035-SG
Publication Date: 2016
$179.00

HISTORICAL DOCUMENT. One procedure for measuring the surface profile of abrasive blast cleaned steel. The measurement technique uses a tape that replicates the surface profile.
Picture for Surface Preparation of Soluble Salt Contaminated Steel Substrates Prior to Coating
Available for download

NACE Publication 6G186-2010-SG, Surface Preparation of Soluble Salt Contaminated Steel Substrates Prior to Coating

Product Number: 24243-SG
Publication Date: 2010
$109.00

The use of coatings in service environments where soluble salt contamination of the substrate is suspected.  Detection, removal, and testing. Cost-to-benefit ratio.
Picture for NACE No. 8 Industrial Blast Cleaning SSPC SP14
Available for download

SSPC-SP 14/NACE No. 8-2006, Industrial Blast Cleaning

Product Number: 21088-SG
ISBN: 1-57590-077-7
$109.00

 Requirements for "Industrial"  - one of five levels of cleanliness of steel surfaces achieved by blast cleaning with the use of abrasives.  (White Metal, Near-White Metal, Commercial, Industrial, Brush Off)
Categories
Industry
Recently viewed
Popular tags
View all

Association for Materials Protection and Performance

© AMPP All Rights Reserved.
Membership Terms of Content Use
Contact Customer Support