Save 20% on select titles with code HIDDEN24 - Shop The Sale Now
Since 1982, there has been a move to Thermal Sprayed Aluminum (TSA) coating in the “splash zone” of offshore structures. Our experience indicates that an experience applicator, good surface preparation and quality of wire combined to achieve required thickness and apply the sealer to seal the entire surface.
We are unable to complete this action. Please try again at a later time.
If this error continues to occur, please contact AMPP Customer Support for assistance.
Error Message:
Please login to use Standards Credits*
* AMPP Members receive Standards Credits in order to redeem eligible Standards and Reports in the Store
You are not a Member.
AMPP Members enjoy many benefits, including Standards Credits which can be used to redeem eligible Standards and Reports in the Store.
You can visit the Membership Page to learn about the benefits of membership.
You have previously purchased this item.
Go to Downloadable Products in your AMPP Store profile to find this item.
You do not have sufficient Standards Credits to claim this item.
Click on 'ADD TO CART' to purchase this item.
Your Standards Credit(s)
1
Remaining Credits
0
Please review your transaction.
Click on 'REDEEM' to use your Standards Credits to claim this item.
You have successfully redeemed:
Go to Downloadable Products in your AMPP Store Profile to find and download this item.
Overview of coatings for a cyclic-temperature environment. Test method, including a heat cycle between 21 to 300 deg-C simulating the dehydrator operation and exposure to salt spray. The performances of the three coatings were evaluated using this method. Factors to be considered for coating selection in the cyclic-temperature environment are discussed.c
In this paper, a new concept named CP by distributed sacrificial anodes (DSA) is presented. The main principle of CP by DSA is to convert cathode area to anode area by distributing anode mass over the surface of the equipment to be protected.
This paper evaluates the resistances to CUI of three types of coatings under severe CUI conditions using a vertical pipe test method. Certain possible improvements in the test method are also discussed.